5:41 p.m.
Hi Jonathan,
Thanks for the pointers, few parameters were wrong in the mig settings.
I could run the dram test successfully.
Now, the sdcard test fails with the following error message in the uart
console:
Fail to mount SD driver!
error! exit(0x0000000000000001)
Is there a specific SD Card we need to use, I have tried the following two
cards
1. SanDisk Ultra SDXC 1 (64 GB, 80MB/s)
2. Lexar Professional SDXC 1 (64 GB, 95 MB/s 633x)
I have cross checked the fpga pin locations, from Nexys 4 Ref Guide
<https://reference.digilentinc.com/_media/nexys:nexys4:nexys4_rm.pdf> Page
22 of 29, for spi_cs, spi_sclk, _spi_mosi & spi_miso.
I have connected the above signals to the corresponding pins in my device
under the SD Card connection section.
SPI_CS -> DAT3
SPI_SCLK -> CLK
SPI_MOSI -> CMD
SPI_MISO -> DAT0
Kindly let me know how to debug this further.
Thanks & Regards,
Anup Kini.
On Wed, Jan 31, 2018 at 6:22 PM, Dr Jonathan Kimmitt <jrrk2(a)cam.ac.uk>
wrote:
The hello world test uses only internal block ram. So not much to go
wrong.
As soon as you exercise DDR memory, the processor will hang if the AXI bus
does
not respond. The situation is complicated by the presence of caching which
might mean
you don't see the problem straight away.
I suggest you run the DRAM example design that comes with MIG generator
(right click on the MIG IP in Vivado and use 'Open IP example design') to
prove that
your MIG settings are correct. This can be done in simulation and the real
FPGA.
If it passes the Vivado example design, it is a simple matter to capture
the settings in
mig_config.prj for lowrisc. Also pay attention to any interface signals
that might be different
in that version of the MIG IP.
There may also be a pre-configured MIG project for your board on the
manufacturer's website already
for comparison. Also check your board revision, sometimes the DDR chip
changes between revisions
and this could require MIG settings file to be changed.
On 31/01/18 12:41, Anup Kini wrote:
> Hi All,
>
> I was able to successfully port the untethered design to a custom Virtex 7
> 2000T device.
> I also ran the hello world example, which ran successfully.
>
> When I try to run the dram test, the print stops after the 1st msg:
> DRAM test program.
> Write block @0 using key 0
>
> I did a little debugging and added a print step inside the dram.c code,
> line: 57, inside the for loop.
> It gets stuck at step 8 (i.e i iterated 8 times.)
>
> SetUp details:
> Vivado 2015.4
> Virtex 7 2000T - xc7v2000tflg1925-1
> lowrisc - untether v0.2
>
> MIG UI Clock @ 100 MHz
> Uart, BRAM, SPI-SD, Core - all running at 25 MHz
> I have configured the axi_clock_convertor to 1:4 ratio for the above clock
> setting.
>
> Kindly let me know how to proceed debugging this issue further.
>
>
>
> Thanks & Regards,
> Anup Kini.
>